Cylinder actuator 70

Cylinder tech info :

Electrically, electronically controlled lift cylinder:

The new design is stronger, faster, silent, slimmer and more precise.

·       Engineered to proportionally retract and extend electronically

·       End points controlled electronically

·       Nonferrous metal construction (brass)

·       Ball bearings

·       Drive: micro-motor with multi-stage gear 12mm

·      Ball bearing drive spindle ----- 2-starts acme screw-precision spindle

·      Stroke 30mm

·      Extended length 125mm (center / center bearing eye)

·      93mm retracted ----- length (center / center bearing eye)

·      Diameter 15mm

·      Force 6.0 kg (it cuts out electronically at about 6kg load)

·      Speed 1.5 cm / sec

·      Operating voltage 12 Volt

·      Required control electronic ESC supplied

The special ESC is a current-measuring control unit. That is, it measures the basis of a 0.1 ohm resistor measuring the current flow during the motor running.

If the current is higher than the set value example maximum current set value = 6 kg load, then the software switches off the ESC.

The software in  the ESC is designed only for 10 NiMh cells or 3 Lipo cells. Nominal voltage of 12 volts is specifically designed for operation of these cylinders.

Dimensions: 15 * 12 * 4.5 mm

Battery and motor connection: Silicone cable 0,25qmm

BEC-supply for receiver

The ESC has its own 5 volt supply which can also be used for a receiver. However, more servos should not be operated on here, as this may affect the current measurement.

Control range

The ESC regulator regulates the speed continuously backwards and forwards with overload protection in both directions.

INCLUDES FREE ESC FOR THE CYLINDER !!